The best selling masonry saw in the USA
OSHA CompliantiQMS362i 16.5" Masonry Saw
Independent Silica Dust Testing
Test Overview
Cutting Equipment
iQMS362 electric masonry 16.5" saw for materials up to 5.5" high, 24" wide and 24" long
Dust Collection
iQMS362 16.5" masonry saw with integrated vacuum, filter and dust containment system
Materials
Manufactured Concrete Paver 4"x8" and Standard Red Face Brick
Number of Cuts
100 thru cuts of red brick + 100 thru cuts of concrete paver
Air Sampling Duration
480 minutes in operator's breathing zone
Testing Laboratory
ALS Global Environmental Laboratory, Salt Lake City UT 84123
Test Documentation
Analytical Results
Sample A — On Person (Breathing Zone)
Lab ID: 2326830001 · Collected: 09/22/2023 · Perris, CA
NIOSH 0600 — Respirable Dust
mg/sample
0.084
mg/m³
0.070
Reporting Limit
0.020
NIOSH 7500 — Crystalline Silica
| Analyte | Result (ug/m³) | Result (%) |
|---|---|---|
| Quartz | <4.2 | <6.0 |
| Cristobalite | <4.2 | <6.0 |
| Tridymite | <17 | <24 |
| Total Silica | ND | — |
Monitoring and Analysis Methods
Air samples were collected at iQ Power Tools, 4635 Wade Avenue, Perris, CA, 92571 during dry cutting activities. Samples used SKC Brand of AirCheck Touch air sampling pumps on pre-weighted 3-piece matched weight 37 mm PVC filter media and SKC GS-3 plastic cyclones (SKC Part #225-100) at a flow rate of 2.75 liters per minute (LPM). Analysis was conducted at an AIHA accredited laboratory, ALS Laboratory in Salt Lake City, Utah, in accordance with current OSHA regulations using NIOSH method 0600 and method 7500.
Result: Total Silica Not Detected
The iQMS362i produced zero detectable crystalline silica cutting both concrete pavers and red brick in an 8-hour simulation. The integrated dust containment system fully captures respirable silica, confirming OSHA Table 1 compliance for masonry cutting without water or slurry.
Disclaimer: iQ Power Tools dry-cut masonry saws are not specifically listed under OSHA Table 1. However, independent air monitoring conducted by ALS Global Environmental Laboratory demonstrates operator respirable crystalline silica exposures substantially below OSHA's 50 µg/m³ Permissible Exposure Limit when the saws are operated with their integrated dust collection systems as intended. Therefore, employers may use the objective data and exposure assessment provisions of OSHA 29 CFR 1926.1153 to support silica compliance. Results may vary based on material type, cutting conditions, and equipment maintenance.